As I have said before. The FRT for the so called phantom non restricted AR10's does not exist. It has been looked for extensively. Those that may possibly be in Canada are ones that simple escaped the clutches of the government in 1996.
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
As I have said before. The FRT for the so called phantom non restricted AR10's does not exist. It has been looked for extensively. Those that may possibly be in Canada are ones that simple escaped the clutches of the government in 1996.
Here is what the selector area looks like for a factory AR10 semi-auto. In order to be deemed importable into the US a sear block was installed in the way of an over sized steel pin. [not unlike a modern colt ar15 sear block] The hammer is defanged from the factory and the selector is specially machined. These rifles are engraved as "AR102 Sporter" because the ATF did not want them cofused with miltary arms. There is also a block inthe magwell to keep standard magazines from being inserted. Only specially made 5 round mags will fit.
Last edited by HHollow; 09-19-2014 at 10:54 PM.
Based on your profile photo you have done much research on the subject!
Time for someone to build a ar102 sporter lower and assemble a rifle for submission! The drawings provided on the other page combined with measurements from an original should make it possible. I wished I never passed up those parts kits a couple years ago!
Hey Can Am.... you did say a drawing ....Nailed it!!!
curiosity may have killed the cat....but at least the Lil bigger died knowing..
Has anyone chacked to see if there are any of the US made old style semi-auto AR10's in Canada? These assembled rifles are not cheap, but it may be the quickest route to a usable AR10. The lowers were made by:
Specialty Arms
Telko
Sendra
Central Kentucky Arms
H&H Enterprises
and a few very small makers like Chasan.
These lowers have no sear hole and some have selector blocks on the outside. Generally, the fire control area is complete unmilled in the region where the sear should normally reside.
Last edited by HHollow; 09-20-2014 at 09:41 AM.
What about a rinco 542??
Last edited by shortandlong; 09-20-2014 at 05:45 PM.
Would there be an frt for each manufacturer of a receiver?Originally Posted by HHollow
I have some additional info Thanx to some fantastic info from a stellar member here on CGN regarding these possible non restricted AR10's in Canada and posted it in my thread here.
http://www.canadiangunnutz.com/forum...4#post10707424
Not sure if it was suggested already. There is a blueprint section on Biggerhammer just right below the manuals. One of which is the Armalite AR-10. It is password protected so if anyone have any means of access....
h ttp://www.biggerhammer.net/manuals/
Posting Permissions
