How did you mount your red dot?
Fitting the stock involved accommodating the charging handle and the block it attaches too. After I did that I puzzled over why it wouldn't fit for a little while, then I realized there was a tiny bit I had to remove from inside the stock just in front of the mag well.
It didn't take me an hour to do.
It would have been easier to fit a wooden stock I think, because the material this stock is made of was hard to cut with just about every tool I tried except a sharp new dremel router bit.
A para stock was what I really wanted, but at this price, I couldn't resist.
Remove rear sight buy a weaver .22 groove size mount put red dot on top- Mec-Gar mags are the cheapest and they are the ones made for Chiappa 9
Heyy, that lookz really good. Imagine a Wood Para tropper {if can be found} can work as easily. So, basically the verdict is still Hit n' Miss... basically worth it if you get one for under $400... with a little tinkering to no known issues..? lol if that exists..? Great Concept, someone needz to give Chiappa a swift kick in the QC.
Last edited by Johnyy; 06-12-2015 at 02:31 PM.
Babyseal, thanks. I looked for para stock but expensive. I hadnt considered Choate, thanks for the info.
Indeed,
it ain't over until the nourishment enhanced non male peoplekind sings.
straightandnarrow
No problemo!
And my thanks to 220 for the info about rimfire rings. I wasn't sure if they were those European 11mm rails....
And I agree about the Mec Gar mags. They are great.
Last edited by BabySeal; 06-12-2015 at 08:28 PM.
Does anyone know where I can buy one of these? Can't seem to find them now.
You can click on the picture of them in the first post or try this.
http://www.theammosource.com/index.p...oducts_id=3952