I found blueprints for a M1 garand reciever on the internet, would norinco be willing to make new garand recievers? ( i have high resolution drawings)
edit: possibly found Blueprints for the entire rifle.
I found blueprints for a M1 garand reciever on the internet, would norinco be willing to make new garand recievers? ( i have high resolution drawings)
edit: possibly found Blueprints for the entire rifle.
Last edited by serbinator; 07-12-2014 at 01:49 AM.
Why is there a shortage of them ?
Pre-orders are horrible for everyone involved. They never go smooth. We will not be doing a pre-order to bankroll this project.
I'm all for it, but I doubt Norinco could beat $50.
they will run out soon. And when they do the prices will go up. Im looking for all the manufacturing blueprints of the m1 garand. so far found the reciever only. Maybe if the blueprints are found for the rest of the parts we can see some norinco garands?
edit: found a book that contains all of the blueprints for every single part for the m1 garand, so what can be done canadaammo?
Last edited by serbinator; 07-12-2014 at 01:23 AM.
perhaps it will be in a few years when available garands dry up? if they can make the m305b for 5-600$ it shouldnt be difficult to make a garand for 5-700$. I am not sure if they already had the tooling set up for the m305b before they started selling them here. Im just brainstorming about norinco making garands here. if it cant be done then oh well.
Pre-orders are horrible for everyone involved. They never go smooth. We will not be doing a pre-order to bankroll this project.