 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Yes these mags can be disassembled for cleaning. Catch the thin edge of the floor plate against the edge of a table or corner and pound down with your fist on the back spine of the magazine. The base plate slides off towards the rear of the mag. There are no clips or retaining pins, they just slide off albeit tight. You can then remove the spring and the follower will drop out.Originally Posted by mildot
delete
Last edited by jonythebeast; 04-08-2015 at 05:50 PM.
i agree with. purchased one, don't fit good, can not use it with my quick strip clip loader, so called "canadian made", throw it aside, never touch it again.
If they suck that badly send them to me, I'll pay shipping..
https://ericaswimmingdream.tilt.com/year1
Hey CGNers. Here is your chance to crowed fund a future Olympic hopeful and current gun nut!!thanks for your help everyone
I second that
you both beat me to it. No, not the best ever, but no where near the worst magazines in the world or anything like that. Would I use them if my families lives depend on it? No, but if that happened, I am pretty sure it wouldn't matter if that little rivet was in the regular 30 rounders
the CGN formerly know as John_in_BC
Hmm, interesting. I bought one too. Works fine in my T97 (with a little sanding) and my NEA-15.
"Among the many misdeeds of British rule in India, history will look upon the act of depriving a whole nation of arms as the blackest." - Mohandas Gandhi
Did you sand the mag or the gun?
Mostly the mag, but did a very little light sanding in the magwell as well.
Still doesn't drop free, but otherwise comes out easily enough.
"Among the many misdeeds of British rule in India, history will look upon the act of depriving a whole nation of arms as the blackest." - Mohandas Gandhi
So you modified a magazine for a .50 firearm to fit and function in a .223/556 gun. That's called manufacturing a prohibited device.
Posting Permissions
Reply With Quote