I don't have a rifle that these will work in yet but do they require any modifications to work in the norincos or poly techs.. I quickly scanned through the pages and saw that they will work in them but didn't see if mods were made
If you have any questions please call or e-mail:
Phone: (204) 748-2454
E-mail: sales@wolverinesupplies.com Retail Sales
I had a feeling that was the case. My apologies for the dumb question, I was asked about it and since I don't know much about guns using other guns magazines I thought I would ask before wrongfully informing someone
We have a somewhat unique situation here. The magazines that fit and work in the 7.62 NATO AIA rifles will fit and work in any of the M14 type rifles. These mags are not M14 mags as they do not have the square hole in the front for the end of the M14 operating spring guide to fit into. This hole is not required when used in the AIA rifle, coincidently it is also not required for them fit an M14 type rifle. It has been correctly pointed out that to make that hole in these mags could put you into the position of possessing a prohibited device, unless you permanently blocked them to a five rd capacity.
We have tested these ten rd mags in original AIA rifles, Winchester M14 (CA), Springfield M1A NM and several different Norinco M14 rifles, the fit and function was as good as any original magazines.
Last edited by Mr Wolverine; 01-11-2015 at 12:56 AM.
If you have any questions please call or e-mail:
Phone: (204) 748-2454
E-mail: sales@wolverinesupplies.com Retail Sales
Tried to add two magwedge adapters to my order but couldn't find them on your website anymore. Are they out of stock? Thanks.
out of stock temporarily, we have more on order
If you have any questions please call or e-mail:
Phone: (204) 748-2454
E-mail: sales@wolverinesupplies.com Retail Sales