M305 receivers

[.308ACADIAN]

What about complete rifles in a parts kit, its the assembly of the parts that's really bad.

[WetCoast]

What about complete rifles in a parts kit, its the assembly of the parts that's really bad.

Damn, that is a good idea I would be into. I would prefer minimal receiver markings unless the quality of the markings were better than has been seen recently. Just a preference though!

[Dyspnea]

we can check

It's been a few weeks, but have you found out if it is possible?

[CanAm]

We will check next time we are in discussions with the factory, likely some time in the next year.

[Dyspnea]

Alright good to hear, look forward to an answer

[safehunter]

Any chance that Norinco could make a LRB m25 style receiver with the scope rail forged and machined as part of the receiver?

x3

These would sell like hotcakes

[buckbrush]

if the INTERNET experts in the U.S. are to be believed, Norinco has not made new Receivers in 15 years.

[1-trident-1]

the theory is they have warehouses full of parts and only assemble as required. so, tapped receivers for scopes, not likely, but all the other packages are a possibility, if the experts are correct. only the chicoms know for sure. so, who has the best connections?

[CanAm]

if the INTERNET experts in the U.S. are to be believed, Norinco has not made new Receivers in 15 years.

Yes, they have decided to start again, as the 19k units left have run out.

[El_Monty457]

Well then, as I said in post #3, whenever you can get these in, (after they resume production and delivery of them), I'd be in for at least 2, maybe 3 M305 receivers, depending on the price point.