AR500 Gong Sets - Available Now!

[NicholasN]

Are these water cut?

Edit:

D'oh. I need to read more carefully. I now see they are laser cut.

[ATRS Shaun]

These are heading out the door before the paint's even dry! Just got a new batch yesterday! Orders can be placed online HERE , or by calling 403-277-7786!

[Beater]

I don't recommend it I have ar500 targets at 1/2 inch thickness and the x39 steel core (which surplus is)
And it puts small pits in the surface.
If used for 500-1000 rounds you will start to damage the target


Anything thing else besides steel core ammo is fine web 50 bmg just not surplus steel core or you get the pitting effect on the surface

even the hardest steel will pitt even without AP

[alberta tactical rifle]

I don't recommend it I have ar500 targets at 1/2 inch thickness and the x39 steel core (which surplus is)
And it puts small pits in the surface.
If used for 500-1000 rounds you will start to damage the target


Anything thing else besides steel core ammo is fine web 50 bmg just not surplus steel core or you get the pitting effect on the surface

At what distance are you shooting AR500 at? I have shot literally hundreds of thousands of rounds of 223 and up to 50 BMG surplus which IS steel core at AR500 targets with no ill effects. I DON'T shoot steel closer than 250 yards however.

[little_airwolf]

10" and under @ 250+.
Good shooting!
Just seeing the 2.5" at 250yds wound be a challenge.

[ATRS Shaun]

10" and under @ 250+.
Good shooting!
Just seeing the 2.5" at 250yds wound be a challenge.

The 2.5" at 250yds is only 1 minute of angle. The equivalent of 1" at 100 yrds. We guarantee our bolt rifles for half that.

[alberta tactical rifle]

10" and under @ 250+.
Good shooting!
Just seeing the 2.5" at 250yds wound be a challenge.

SO hits on a 2.5" gong at 1000 yards would really impress you then? The reason for 10" 5" AND 2.5 " was 1.0 MOA, .5 MOA and .25 MOA at 1000 yards.

[ATRS Shaun]

New stock just arrived in. More AR500 targets available on our website HERE.

[calvados.boulard]

Regarding 7.62x39, I shot some DA non-corrosive steel core, and Norinco non-corrosive steel core at a competitor's 3/8" thick AR500 and had significant cracking and chipping of the plate after around 600 rounds. ATRS, from what I'm reading this should not be a problem with your targets?

Thanks ATRS,
Cal.

[lanis]

Shaun, price is good but how about other sizes than listed?

Perhaps 10 in, 8 in and 6 in, as a set?


Regards,
Dan