[Richmond Gun Shop] AGAIN！ DANIEL DEFENSE M4 CARBINE, MK18

[westcoasthunting]

Just can't have enough for today!
This is in Tan color, HOT! HOT! HOT!

Here we go again from Daniel Defense website :

Use what “THEY” use. The Daniel Defense MK18 features the railed forend Daniel Defense currently provides to USSOCOM and a 10.3” Cold Hammer Forged Barrel. The Flat Dark Earth MK18 rail system features the Bolt-Up System and has been rigorously tested prior to fielding by USSOCOM (currently over 15,000 units). The 10.3” barrel is the same length in use for the MK18 upper most commonly used for CQB operations. The MK18 Factory SBR by Daniel Defense is unmatched in size, weight, and performance. This rifle also comes with the newly designed, rugged and comfortable Daniel Defense Buttstock and Pistol Grip.

NFA DISCLAIMER
This firearm is a regulated item by the National Firearms Act (NFA). Please check with your local and state municipalities for any further regulatory requirements. It is the buyer’s responsibility to make sure they comply with all NFA rules and applicable laws.

MATERIALS & CONSTRUCTION
LOWER RECEIVER: Mil-Spec with Enhanced Flared Magazine Well and Rear Receiver QD Swivel Attachment Point. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized
UPPER RECEIVER: Mil-Spec with Indexing Marks and M4 Feed Ramps. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized
BARREL: Chrome Moly Vanadium Steel, Cold Hammer Forged, 1:7 twist, 10.3″ Govt Profile, Chrome Lined, MP tested, and Mil-Spec Heavy Phosphate Coated
GAS SYSTEM: Pinned Low Profile Gas Block CNC Machined of 4140 hardened steel and Mil-Spec Heavy Phosphate Coating, Carbine Length, Direct Impingement
MUZZLE DEVICE: Daniel Defense Flash Suppressor, 17-4 PH Stainless Steel, Salt Bath Nitride Finished
BOLT CARRIER GROUP: M16 Profile, Mil-Spec MP Tested, Chrome Lined, Properly Staked Gas Key
BUFFER: H Buffer
SIGHTS: Sold Separately
HANDGUARD: Daniel Defense MK18 RIS II, CNC Machined of 6061-T6 Aluminum, Type III Hard Coat Anodized (FDE or Black)
RECEIVER EXTENSION: 6 Position Mil-Spec 7075-T6 Aluminum
BUTTSTOCK: Daniel Defense Buttstock, Glass Filled Polymer with Soft Touch Overmolding
PISTOL GRIP: Daniel Defense Pistol Grip, Glass Filled Polymer with Soft Touch Overmolding
RAIL PANELS: Daniel Defense Rail Panels made from Santoprene, heat resistant to 300° F.
Made in the USA!

[westcoasthunting]

Please check link here to order.

http://www.westcoasthunting.ca/produ...-carbine-mk18/

[Mere_Mortal]

Are these still avail? If so how much?

[AtomLew]

Can you bring some Daniel Defense Mk18 RIS II?