Dominion Arms 12.5" and 18.5 Barrel for Grizzly/Remington 870 Shotgun 79.99 $$$$

[gunnuts]

is there a magazine extension that would give a flush fit with the 18.5 barrel?

[Dantes Inferno]

is there a magazine extension that would give a flush fit with the 18.5 barrel?

I think the remington +2 is designed for an 18.5" barrel.

[gunnuts]

I noticed in the description of the 18.5 that even though the title says it's for dominion and 870 shotgun, the description states that it is for the MAGFED grizzly shotgun, will it be OK with a regular tube fed remington 870 express?

[EL34/6L6]

I think the remington +2 is designed for an 18.5" barrel.

The Rem +2 will give a flush with muzzle look, but will only turn the gun into a 6+1, not a 7+1 as intended. Look at an S&J Hardware +2 instead.

[gunnuts]

The Rem +2 will give a flush with muzzle look, but will only turn the gun into a 6+1, not a 7+1 as intended. Look at an S&J Hardware +2 instead.

I think the remington +2 is designed for an 18.5" barrel.

Thanks for the infos.

Now I just need to confirm that the 18.5 will fit a regular 870 express!

[Dantes Inferno]

Ya dude, your good to go. You should get the 12.5 as-well. I have 12.5" / 20" (and +3 ext.) / 26" Rib that I can change for whatever I'm doing. I doubt well see this kind of pricing again.


Also this looks about right for a rear site.

[gunnuts]

Thanks a lot Dantes!

I already have the 12.5 on my 870 with the S&J CQB stock and rail, which is flush with the feed tube and looks amazing, but I only wanted to be sure the fit of the 18.5 was the same as the 12.5.
For 80$, the 18.5 is a no brainer, I'll get it just in case I ever want to go hunting or shooting clays with my 870 (I'll have to thread it for chokes though).

I'll go order one right now!

Ya dude, your good to go. You should get the 12.5 as-well. I have 12.5" / 20" (and +3 ext.) / 26" Rib that I can change for whatever I'm doing. I doubt well see this kind of pricing again.


Also this looks about right for a rear site.

[Dantes Inferno]

Thanks a lot Dantes!

I already have the 12.5 on my 870 with the S&J CQB stock and rail, which is flush with the feed tube and looks amazing, but I only wanted to be sure the fit of the 18.5 was the same as the 12.5.
For 80$, the 18.5 is a no brainer, I'll get it just in case I ever want to go hunting or shooting clays with my 870 (I'll have to thread it for chokes though).

I'll go order one right now!

Try some reduced recoil loads and see how tight they pattern before threading for a choke, I saw some stuff recently that showed a 14" cyl. bore patterning as tight than a 22" barrel with a choke.

[hdls]

Will the 18.5 barrel fit a 4+1 870?

[JustinF]

all grizzly barrels are chambered in 3"

Who did you speak to?

Spoke with Daniel Ryan via email about the chokes. Your website states that 18.5 grizzly are 12 gages 2 3/4 caliber