Hi! I can't put my barrel in.... The bolt don't want to move...is there a tricks???? We're a couple who buy it and we have all the same problem.. Someone help please.
s!
Hi! I can't put my barrel in.... The bolt don't want to move...is there a tricks???? We're a couple who buy it and we have all the same problem.. Someone help please.
s!
Last edited by bahamot; 08-29-2015 at 07:29 PM.
Try holding the spring down with one hand and let the op rod fore end slip over the guide. Then let bolt slide in? I think it's a tight fit at the op rod fore end and won't line up properly with spring resistance???
Then put in the bolt charging handle.
That will hold ever thing in place.
Then drop in your barrel, then front stock and locking nut
Another tip is to assemble the gun vertical on a counter.
Muzzle up..
Behemot, you need to be patient. I had the same problem. Just patients
that's the thing.. my patient reach is limit ...hahahahaha
Your trigger is cocked back ? Or out of the gun?
Hey CA ! I asked a while back . But any mags for the M1000?
Re: The mags
I remember in a post before that CanAm bought the whole lot of these from an R&D facility (ie: not a full production run, so they bought everything they had). The had mentioned a few extra mags, but they came off scratch and dent firearms so to say, so you'd pay most the price of the gun for them
Anyone doing any Long-Range, Pistol, or Action-Shooting in or around the Elk Valley/Crowsnest Pass? I'd love to tag along, send me a PM
yeah!!! it's done !!! my problem was in the main rode, she's not perfectly round....so the part who attach to the bolt can't slinde over it.... sandpaper was the solution finally......