The milling of the reciever magwell go fit the adapter in, I had an endmill, let's say they sell china crap locallyOriginally Posted by MagWedge Industries
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
The milling of the reciever magwell go fit the adapter in, I had an endmill, let's say they sell china crap locally
Is it wrong to love the clack clack bang, but wanna run from a click tick lol
To be honest I cannot even recall what size we used as it has been years and my machinist did the work.
That being said, as guys do the conversion with dremel tools I suspect any reasonable size bit should work. A quarter inch sounds reasonable.
1/4" carbide endmill works well
Can't find it on your website
see post 78
product sold out and new production suspended pending firearms legislation
I have to ask if I install the AR adapter can I use the regular mags, not factory but the tapco ones??
I was just looking at my SKS thinking about that lol
Is it wrong to love the clack clack bang, but wanna run from a click tick lol
You will need to remove the adaptor first.
I found out I cannot use the standard magazine after it's milled, going to have to install the magazine and you JB weld or some other filler to make a feed ramp
Is it wrong to love the clack clack bang, but wanna run from a click tick lol
I lost the adapter for a spell, and tried to convert it, lost the original stock also haha, I put things down and they walk, got the stock gonna inlet it this weekend, and the adapter I have it now, but ones you mill it out the rounds won't angle I to the chamber
Is it wrong to love the clack clack bang, but wanna run from a click tick lol
Posting Permissions
Reply With Quote