Couldn't you just weld the flash hider on? The US would count that as barrel length (even though we don't). That should get you to 16" (since the barrel is already 15.7").Originally Posted by Petrock
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Couldn't you just weld the flash hider on? The US would count that as barrel length (even though we don't). That should get you to 16" (since the barrel is already 15.7").
μολὼν λαβέ
Yeah, that was my plan for 2016. Just pin & weld a muzzle device on there.
Will that meet the legal requirement for barrel length?????
Doesn't matter, anymore. We're only good for filling sandbags for floods and saving people during winter storms. Other-wise we're kicking posts and crazies who are over worked, over taxed, underpaid and never truly appreciated.
Yes, in the US this is quite common, lots of very long flash hiders were made specifically to allow 14.5" barrels to come up to 16" long. They must be pinned and welded over.
I should note that this is NOT the Canadian rule.
"Well done is better than well said"
Benjamin Franklin
Just dropped my order in for one of these! Could not resist any longer !
"Well done is better than well said"
Benjamin Franklin
Thanks Ryan, received mine last week and no blemishes or marks, looks perfect....Thanks again SFRC!!!
I received mine also. It's a beauty. One very minor knick on the inside of one of the rail slots. Non issue for me. Actually fits tighter in my norc lower than the norc upper does.
"Victory favours the prepared"
Upper arrived today. It is PERFECT!!!!! there is not so much as a tiny scratch on it. Woo hoo!!!!
Last edited by Canadian eh!; 11-27-2015 at 04:49 PM.
"Well done is better than well said"
Benjamin Franklin
Posting Permissions
Reply With Quote