Mossberg factory 14" shotgun barrel kit

[gunnuts]

If you install the Shockwave Raptor grip; You are just over the 26" minimum non-restricted length.

A normal pistol grip will put you into the restricted category.

Could you tell me who sells the raptor grip in Canada, I can't seem to find any dealer, and shockwave technologies stated that it does not ship out of USA.
I would like to get one for my rem 870 with 14" barrel.
Thanks

[Repro77]

Could you tell me who sells the raptor grip in Canada, I can't seem to find any dealer, and shockwave technologies stated that it does not ship out of USA.
I would like to get one for my rem 870 with 14" barrel.
Thanks

Ebay is where I got mine, no problems.

[Xero]

Just got off the phone with Dan at CSC.

Apparently it's just the barrel, no magtube. No forend. 150$ ish.
He doesn't know if it's heavy barrel or not.

Either way, without the shorter forend assembly and tube you're hooped for an A1.

Sounds like the Remington 870 14" barrels at the CSC which are $180. The Mossberg 590 ones are $475 at CSC.

The Mossberg ones are more because they come with the correct-length magazine tube and possibly some other things (hand-guard?)... I'd have to check with them again.

Edit: The Mossberg 590 ones at CSC include barrel, mag tube, spring, and hand-guard.

[Greenhorse six]

A custom order of barrels made at the minimum length to fit flush with a basic 500 would be a much more economical option. You'd end up somwhere around 15" in barrel length. I think that would suit most people.

This , but for the 590 .

[gunnuts]

Ebay is where I got mine, no problems.

Great, thanks!

[Mossberg_590A1]

This , but for the 590 .

Though I prefer the 590 to the 500, you could have a very inexpensive SBS by going the 500 route. In terms of volume, I think it would be more popular.

[shotgun-bob]

if mossberg (or??) produced a (15"?) barrel for the 500 that was flush to the standard tube mag
(like their 20" barrel fits on the 7-8 shot) it would be a HUGE seller!!! most likely COULDN"T KEEP THEM IN STOCK
What goes on in the states IS a factor,
but come on...this is OBVIOUSLY a good idea
JUST SHORTEN THE 18.5" BARREL TO 15"ish ALREADY

[Dexter Morgan]

if mossberg (or??) produced a (15"?) barrel for the 500 that was flush to the standard tube mag
(like their 20" barrel fits on the 7-8 shot) it would be a HUGE seller!!! most likely COULDN"T KEEP THEM IN STOCK
What goes on in the states IS a factor,
but come on...this is OBVIOUSLY a good idea
JUST SHORTEN THE 18.5" BARREL TO 15"ish ALREADY

Agreed.

[North_Sylva]

Does it also come with the shorter forend that is required to function?

Yes it does.

[North_Sylva]

Wow! In the USA these are basically made out of "unobtanium". What a score. Does this possibly mean that more 14" shotguns will once again become available?

Unlikely. As you have said these barrel kits are next to impossible to obtain. It's highly unlikely there will be any more leaving the United States.