The fit and finish is really nice, was really easy to install, I just had to move my mag and bolt release over to new receiver, took me about 1 hour to convert everything over. I have never been a big fan of polymer gun parts, but that is the way these days. I think this is a perfect addition for these guns. I am getting a lot of messages asking where I purchased the receiver from, here is the link, I dealt with Matt he is one of the owners.
http://www.toothandnailarmory.com/product/TN094.html
Last edited by Curtis264; 04-27-2016 at 10:45 AM.
Just finished shooting my new shotty for the first time, what a fantastic gun. I just put in the heavy ring after thoroughly cleaning the gun to get that heavy oil, and then re oiling. I started off with Federal 2 3/4 target loads #8, put threw 50 rounds, not a single jam even with heavy load seal, put threw another 50 rounds of a very heavy reload and it worked perfectly, no jams, no misfeds. Gun worked perfectly, I am really impressed, I was expecting the that target loads would not work with heavy seal but it proved me wrong
First one was not great for me, but TI sent a new replacement that runs perfectly....
Last edited by scuba_cowboy; 11-18-2016 at 09:27 PM.
This is something you should all check, when I pulled mine apart the bolt that holds the two receivers together was cross threaded, I had to re tap the upper receiver, use an M8 1.25 tap to correct this if you have the same problem, for the handguard nut, I re-tighten every 20 shots or so, I find it is constantly coming loose
This is exactly what happened to me.
Very easy fix. Phillips screw driver to loosen top screw on butt pad.. then 6mm long Allen key with extension to tighten the bolt by the receiver. I tool mine apart completely, gave it a thorough cleaning.
Plus my stock release was broken... the pin has a slot in it that somehow bent and the spring was stuck up inside. Couple retaining pins and it cameout. Another easy fix. This stuff shouldn't be happening but at least it's not bad to repair. The knob that holds the forearm on is crap. The threads feel cheap and rough. The tolerances are not good on the forearm either... I have to tighten that knob tighter than hand tight so I don't have play.
Just got mine ready for turkey hunting on Saturday.
Last edited by Francooch; 05-03-2016 at 09:18 PM.
Me too, but for Bear on Sunday with slugs!!! Saturday for Turkey will be my hunting Stoeger M3500 shotgun with a Primos JellyHead extended choke!