10mm Takedown Carbines!

[Can-down]

A long loaded 40S&W is just a barrel swap?

If so how much is a second barrel?

It would be pretty cool if the 40S&W barrel would feed from Glock 20 mags and avoid having to buy the smaller mag well.
A 10mm/.40S&W combo unit with 2 barrels and maybe 2 recoil springs could be good value.

I'd be interested in a .45 barrel/mag swap kit. I assume these would fit on a 9mm.

I think the best value if you want conversions that require the two different mag wells, is to go for the full meal deal...... we just need some CDN dealer to be the first to offer it.

[ESP]

Check out this article, over 3000 FPS in a 10mm ASR.....
http://www.americanrifleman.org/arti...urvival-rifle/
Ya, i know its a light grain bullet, but 3000 fps!

" the blue ribbon for bullet speed went to the new Liberty Civil Defense 60-gr. nickel-plated copper hollow point. This round scoots right along at 2400 fps when fired from a pistol. Shot from the ASR, bullet velocity averaged 3087 fps with an impressive muzzle energy of 1269 ft lbs. Accuracy was on par with the Double Tap load delivering a single best group of 2.05 and an average of 2.22. "

[cbabes]

I'm pretty skeptical about that, though I have never used 800-X with a 180grn. I do get some insane velocity using 135s though... 800-X is such a pain to work with unfortunately.

I would have been skeptical as well. I just double checked thinking I messed up the 180grain and maybe it was 155 grain since I reloaded those as well and the FPS out of the carbine was 1800fps but they were 180 grain projectiles. 800 does not meter well I agree. I also decided to look at other loads from other people and there are 1475fps results using 10.5 grains of 800-X with people using 10mm 1911s.

[Percussion]

It would be pretty cool if the 40S&W barrel would feed from Glock 20 mags and avoid having to buy the smaller mag well.
A 10mm/.40S&W combo unit with 2 barrels and maybe 2 recoil springs could be good value.

I think it would probably feed fine.
That's a package deal I'd go for, already sent an email to be in for the next batch

[Beater]

I was a 10 mil fan until I found 400 corbon same if not better ballistics without all the high preasure. zero feed issues I have a couple 1911s in this and love em stricktly a reloading number now but brass is easy easy to make

[heineken44i]

Neat.

[Riflemen]

I've been in the market for a good survival gun that is not a .22 LR... This could be a contender for my dollars definitely.

[SierraIX]

nice gun

[Blue_Fish]

Will any of the 10mm be available with threaded barrels and or colour options?

[hical.ca]

All the 10mms we brought in were threaded, we will consider colour options when the factory finishes our next run.