well as we have posted this last 3-4 months we are moving back into our AR15 products, 2yrs ago when the market crashed we were about to launch our own AR15, AFTER 2YRS OF WORKING ON PARTS source, prototyping and testing on parts we could make in Canada, bolt carrier, uppers lowers barrles. we pulled the plug as the market was being flooded.
we are slowly moving back into the parts, and today we have finished testing out mil spec m4 buffter tubes, all is looking well, specs are good anodizing is good, but the castle nut and end plate came back from heat treating and black oxy finishing shiney not bead blasted
Small issue as we will send them back for blasting this week as we have shotgun mag tube to be finished.
I,m also happy to say we may use up the 5000 M4 buffer springs we had made 3yrs ago LOL
we will be listing these on our website today, and also contacting our dealer, as of just now one shot tactical supply and firearms outlet canada are going to pick up both the m4 tube set and our ar15 lower parts kits.
next up will be H1,H2 and H3 heavy buffers, again the buffer bodys have been sitting here finshed for 3yrs, we are gettign the carbide inserts cut at the end of the month.
As 80% of these parts are made by us, or a sub contractor in Canada, we should have a steady flow by late spring.
any questions please feel free to post here
More info to come
BBB
LINK TO PRODUCT
$59.99
http://sjhardware.com/store/modules....oducts_id=1017