The Varmints are coming!!!!

[alberta tactical rifle]

Is the MV a standard 0 MOA upper rail?

The is no inclination in either the Modern Hunter or Modern Varmint scope rails

[Sqr]

Rick, the mods I did to your mags helped. But it didn't solve the fail to feed issue I am having. It seems the follower and the weakness of the spring allow the round to "nose dive" and get hung on the front of the mag. Thus causing the ftf. The amount of plastic I filed off helped, I believe. Out of 60 rounds fired, I had three ftf's. One from each magazine.

That doesn't sound like a lot, but I also tried a LAR15 ten rounder. Zero issues there. I have a couple of Beowolf mags coming this week to try as well.

I just don't have the confidence to try your mags in competition. The LAR's are perfect except for their length. I have a few ideas how I can extend them, but franken-mags don't really give a me a lot of confidence either. I am really looking forward to the Beowolf mags.

I will report back.

http://shop.gsdesigns.ca/ASC-Type-1-...ions-LAR-F.htm

I use them and they are very good.

[6MT]

...

[Battleworn]

Can't wait to get my rifle! 5 months min to go!

[techi870]

I got the chance to do my first long distance shooting with my MV this week. I had no problems hitting plates at both 350 and 500 yards with it. I put a 1-6 Vortex strike eagle on my MV and after sighting it in wasn't sure how it would perform over 100 yards. After this week I don't have any doubt on how I've got my MV setup. I actually got board of hitting the plates after emptying two mags on each of them.

[quorum]

Just drove 5.5 hours round trip to pick this baby up! Was nice to finally check the shop out, and meet some of you guys. Very impressed with the fit and finish of the rifle, and love the color! Can't wait to get it out and test it.

What is this colour scheme, and did ATRS apply the paint?

thanks.

[quorum]

What type of cerakote is used on the barrels? Is it the high heat dissipating stuff?
http://www.cerakotehightemp.com/fini...ack-oven-cure/


thanks.

[alberta tactical rifle]

What is this colour scheme, and did ATRS apply the paint?

thanks.

The color is burnt bronze and was coated here in house.
We ONLY use the heat cure CeraKote, the air cure does not seem to stand up as well.

[quorum]

The color is burnt bronze and was coated here in house.
We ONLY use the heat cure CeraKote, the air cure does not seem to stand up as well.

* How much is the burnt bronze coating option?
* Will the CeraKote retain heat and therefore slow the cooling down of the barrel?

[quorum]

Can someone please advise what's it like shooting the rifle with just a thread protector?

muzzle flash?
recoil?
blast?

thanks.