did you have to mod the heat shield to fit?? love the look on the shorty.
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
did you have to mod the heat shield to fit?? love the look on the shorty.
Apparently there are some in parts. I'm still waiting for a response, but shoot them an email if you need one.Originally Posted by kevin82
I am a kit hor(der)
I sold my 8.5" to finance a 12 inch. 8.5" is a 1 trick pony, whereas the 12" will take any 870 pattern barrel. That way I can wap between 12, 18, 20, 30....whatever. That way I can get the ultimate enjoyment out of my Lego gun <3
Last edited by ThatM305Guy; 11-26-2016 at 10:56 PM.
I am a kit hor(der)
Any 8.5" standalone barrel I can buy?
Where'd you find the heat shield??My 12.5 was threaded. It was also drilled/tapped for a scope rail and came with a rail in the box. Center Griz. and bottom pic
I am a kit hor(der)
ATI heat shield that I cut down and dremelled out a notch to fit over the front sight.
It's better to have questions you can't answer, then answers you can't question.
When you have no property rights, YOU ARE THE PROPERTY!
WEXIT, IPSC, CCFR.
Which end did you cut down? It almost looks in the picture like you welded a tab on the end that the mag cap holds on?
I am a kit hor(der)
Does this 12.5" BARREL fit in the "Remington 870 Express 3-1/2'' 12-Gauge Super Magnum"? Any modification needed during the installation?
This and more details can be found in.plenty of other threads. Short answer is yes.
Are you allowed to eat doughnuts private Pyle?
The heat shield is for a 18" barrel. Just cut the back end off at the correct length then make a rectangular notch to fit over the front sight, leave the front 1/2" or so intact and notch back from that point.
It's better to have questions you can't answer, then answers you can't question.
When you have no property rights, YOU ARE THE PROPERTY!
WEXIT, IPSC, CCFR.
Posting Permissions
