All-New: Type 81M

[Outdoorslover01]

Received my under folder yesterday, but for some reason it has a lot of grease on the gun.

Any tips on how to degrease it ?

[JasonGTA]

Received my under folder yesterday, but for some reason it has a lot of grease on the gun.

Any tips on how to degrease it ?

They're oiled from factory to preserve the metal. Use rags or paper towels and some elbow grease and you'll be good to go in no time. Make sure the bore is clear of all oil and grease as well

[Wesley28]

I got a dud. the cleaning rod has to bend to fit properly! https://ibb.co/MhfVnfS

[JeffMan]

I got a dud. the cleaning rod has to bend to fit properly! https://ibb.co/MhfVnfS

Are you saying your cleaning rod is bent? Or is your barrel out of alignment?

[bfiles]

I got a dud. the cleaning rod has to bend to fit properly! https://ibb.co/MhfVnfS

They all bend to fit tight in their holder

[hunterhenderson]

I got a dud. the cleaning rod has to bend to fit properly! https://ibb.co/MhfVnfS

not uncommon, hows it shoot?

[hunterhenderson]

Nope lol

we will be watchin

[Wesley28]

not uncommon, hows it shoot?

I set the irons to 0 (after 4) which is the highest setting and the sight picture still won't come up high enough. I'm sure its a cheekweld issue though

[hunterhenderson]

After SA shipment both the specification was tightened and proceedures were set in place to measure and catch rifles with trunions placed out of specification. However the odd one does slip through, we have one confirmed case so for on M shipment, it is 0.5mm out of spec. Historically the T81 rifle has been 99.95% within specification.

The one metric that has been 100% is the rate of function. Despite selling in 5 figures numbers of rifles, we have not had a single rifle come back because it wasn't functioning properly. Even range guns going through 10's of thousands of rounds only need wear parts replaced on rare occasions, which we do under warranty.

Mine actually was sent back because without a magazine catch it could not function

[bfiles]

I set the irons to 0 (after 4) which is the highest setting and the sight picture still won't come up high enough. I'm sure its a cheekweld issue though

?!!??!? Either your front sight post is just adjusted to low or you aren't aiming properly also, out the rear sight to 1 and see