The two main components in the Hera carbine kit: the GCC and a Glock (the pin and block have been pre-installed).
The barrel shroud is pre-configured for the shorter Glock 19 (etc.) models. It's easily adjusted for the full-length Glocks
via two bolts underneath the side rails that hold the barrel shroud in-place.
On the left you can see the new stainless steel pin and the block that replaces the rear sight.
On the right are the remaining parts: charging handle (2 pieces), front bolt (2 pieces) and 2 c-clips.
Here you can see the aluminium/steel-reinforced interior of the GCC, the rail guides and a close-up of the charging block.
The flared ejection port on the GCC and a side view of the charging handle block (ambidextrous).
A close-up of the stainless steel pin. The Glock slides in and is held in place in the front by two rails on the bottom of the
stock that align with the rails on the Glock. The pin slides into the u-shaped groove on the left side of the stock.
The pin is punched through a hole on the right side of the stock and held in-place by two c-clips on either side. The
steel and aluminium charging handle installed on the left - which can also be installed on the right.
The final step involves inserting a bolt through the slot in the Glock rail to firmly secure it to the GCC.
The finished product. This GCC is configured with a standard Glock 17, CAA FGG2 folding front grip, Surefire X200 light,
Magpul XTM rails, MBUS and an Aimpoint H-1 on LaRue-LT660HK mount (allows cowitness with the BUIS). The sling I
went with (not pictured here, but you can see it in the first image) is a 2-point tactical detachable from Mako.
..........