UPDATE: Rossi Ranch Hand Mares Leg

[Can-down]

Mine was a Rossi 92 blank

Brutal.
They sould have left the hole unfinished if that's the amount of fitting required.

[hamerdwolfpussy]

OMG is this thread still going

[Can-down]

I swapped mine for a curved lever/curved lower tang/deluxe stock... From another rossi

Let's see it.....
Where did you get the parts?

[Can-down]

OMG is this thread still going

It will never die.

[SHELL SHUCKER]

What tics me off is the fact that it was bought pre-finished ready to install. Now they do say some minor fitting may be necessary but this goes way beyond that so much so if and when i do get it to fit I will have to refinish the complete stock. I sent an email to Boyds with photos so I expect them to reply after Easter is over.

Shellshuckers stock looks pretty nice.

I got my stock from PGW & it required more work than the Boyd's one I fitted to a Rossi Trapper. Making the butt plate was a job of it's own.

[bushpilotmexico]

Just curious as to where you got your full stock. Mine arrived from Boyds last week and it's a terrible fit so much so I don't think any scrapping or grinding is going to help especially since the hole for the tang screw has been drilled.

Just an update on my Boyd's stock. Boyds has stepped up to the plate with a big apology. They sent me a prepaid UPS label and what I did was visit my friendly dentist and scrounged some impression material and plaster of paris. I took and impression of the wrist area as it fits on the tang and then poured it up in plaster. I put this in the box along with the stock they sent me and sent it back.

I'll keep everyone undtaed.

[Buckhunter123]

My mares leg stocks needed a lot of fitting I ordered the rossi 92 stock for my rossi and it's finally coming together needs more work. Man boyds stock aren't even close especially the tang holes and the hand guard was the worst.

[wbaad]

OMG is this thread still going

Guns are still going and lots of good info

[Saleen84]

I had to fill the hole with dowel rod and re drill my boyds stock. Fits rather nice now.

[bushpilotmexico]

Just got the word from Boyd's that the stock I returned fits the mock up of the Rossi 92 receiver that they use on site. They said I must have an odd ball receiver. Personally I can't figure out why Rossi would have used one size receiver for their model 92 rifle and another for the Ranch Hand.

They offered to refund my money but I said send it back and I'll make it fit.