This Space For Rent
How are the stock sights on these kits? Plastic? Metal? Throwaway?
they are plastic but mine seems to be very accurate with the open sights at 25 yards
these opinions are not unlike my lower intestine....
STINKY, and LOADED WITH DANGER!
If guns kill people, do keyboards cause spelling mistakes? When seconds count police are only minutes away.
Homer Simpson: [flipping frantically through the Bible] This book doesn't have any answers!
Silence it golden. Duct tape is silver!
the new mags showed up thismorning and even though I had to swap out my extended mag release for a original 1022 flat one they fit great and look sweet on that stubby build! thanks HICAL! now if promag only made the Marauder kit with a fixed stock I would own 1
"ASSAULT RIFLE" :liberal/ndp word for rifles that DONT suck!!
YOU CANT FIX STUPID!
"Those who hammer their guns into plows will plow for those who do not." -Thomas Jefferson
Moose dont care if I can SPELL or NOT!
WE ARE THE CANADIAN PROMAG/ ARCHANGEL IMPORTERS.
Check out our new retail store, OPEN 7 DAYS A WEEK! : MAP
ARCHANGEL SKS preorders now being taken: email@example.com
-High Caliber Services Corp. Check out our CGN forum!
-The Best Selection of SKS, Mini 14, 10/22 & Shotgun accessories.
-PAL, RPAL & CORE courses for the GVRD & Fraser Valley.
-Contact: 604-289-4867, 604-BUY-GUNS
- Email: firstname.lastname@example.org
Received my replacement feed lips and new mag this week.
The replacement lips looked like 1st Gen lips as the metal wire was still able to dig into my thumb. Got it out to the range thought, and flawless, %100 good to go. The new mag was just as good actually better. As it is a 2nd Gen, with the new metal "mag lip" on it. This is where I started having a problem with my first mag.
Because the gen1 mag has the composite "mag lip" on it, it wore down a lil bit (I admit, it may have been caused by my aggressive reloads while trying to dump 4 mags asap). So now the mag seats, but if you put any rearward pressure on the lower half of the mag, it will become unseated and drop out.
However this is NOT an issue with the gen2 mags.
Thanks highcal, for another great transaction. (looks like I may be ordering a few more mags in the near future, as I hate reloading after each one.)
23.Only one sigline picture is allowed, and the height of the picture must be no more than 100 pixels.
When I ordered the Marauder stock and saw the G36 optic in this thread, I had to get one....and it came today!
It is made well, but you do need to get in tight. I threw the red dot on the top picatinny rail just to see how it looked...might need a halo or a mini...(My iPhone pics suck)
Last edited by berger; 11-29-2011 at 09:34 PM.
Got my kit from Dave yesterday! Thanks again.
Anyone have any suggestions on how to remove the ruger stock sights? I beat the crap outta them last night with no success. I'm going from left to right as noted by others on youtube, but im having a hell of a time removing them.
May get out the heat gun tonight and try heating it up a bit??
Read -> Comprehend -> Post