Will be on standby for 3 sets........need to finish lowers before the weekend inspection ...lol
Will be on standby for 3 sets........need to finish lowers before the weekend inspection ...lol
Audi, vide, tace, si tu vis vivere in pace.
Any update/ETA? I've got a need for a couple sets of the 90's...
μολὼν λαβέ
PM inbound.
Still looking to grab a couple of these too. Are there any other 45 degree safeties on the market and available in Canada?
jjr, we do have the 45 and 90 degree selectors in stock.
Email me at justin@theshootingedge.com with what you're looking for.
Sweet! Sounds like good news...email/PM sent.
μολὼν λαβέ
E-mail sent.
I phoned and completed the order...2 sets on their way...sweet!
μολὼν λαβέ
What modification do you have to make to install the short throw lever?
I'm a small petty little man who takes pleasure in the pain and suffering of others.
CSSA Member
CDP RSO
There is a small steel pin in the axis of the B.A.D. short throw selector. This is to prevent installation into normal AR-15 lowers with standard 270-0-90 degree selector markings.
Why? Because when set to Fire, the Short Throw selector doesn't actually point directly at the 90 degree position. It sits at 45 degrees. For an unfamiliar user it doesn't point to 'Fire', but it WILL fire. Liability reasons.
Thus:
15 minutes with a file will take it off.Disclaimer - The 45 degree 'Short Throw' A.S.S. will NOT fit standard AR-15 receivers without modification. Modification of the safety voids all warranties expressed or implied. Buyer assumes all other responsibility for any loss, damage, or injury to persons or property arising out of, connected with, or resulting from the use of these products, either alone or in combination with other products/components.