Damn. I just bought mags and the polymer coupler from Questar
Damn. I just bought mags and the polymer coupler from Questar
Here are different configurations both with angled mags and the straight ones. For the angled mags, you flip the coupler around and install backwards. They do tend to slip apart depending on the type of coupler. I solved this issue using 3" electronic shrink tube...
"If you have a problem & think that someone else is going to solve it for you then you have two problems"
Member: CSSA & the über-powerful CGN Gun Lobby
كافر
That 3 inch shrink tube is a great idea I'm gonna do that for sure, thanks for that
I have the same ones. These will fit 10 rounds no problem AND insert on a closed bolt. I know a few people with the grey ones and they will only hold 9 rounds, and won't insert on a closed bolt. Got mine from canadaammo.com too. Great mags, just don't expect them to be delivered quickly. I took 15 days to get mine.
You can't fix stupid.
hmmm to put those mag couplers on backwards you had to cut your mag in the bottom a little bit right ?
i just tried to reverse my new lar mag with coupler, it did not work, the extended piece on the coupler is very easy to sand off, but on the mag it self, one end of the mag extend to sit flush with the rails that the floor plate rides on, effectively disabling the coupler to be inserted from that direction, since the mag is made of steel, a power tool is going to be required