How is this thing thread onto the barrel? Just by heat thread it on hand tight or is it actually two pieces?
How is this thing thread onto the barrel? Just by heat thread it on hand tight or is it actually two pieces?
Just screw it on, no heating required.
If you have any questions please call or e-mail:
Phone: (204) 748-2454
E-mail: sales@wolverinesupplies.com Retail Sales
What's the shroud made of? Aluminium or steel?
Reviving this dead thread with NOOB questions...
I'm assuming this will work on the CSA?
Does this need to be installed by a gunsmith? Or the front sight removed by one?
Attaining a lifestyle nothing short of enviable...essentially, living the dream.
This is the first time I`ve seen this post ,very interesting (thanks for reviving this post LuckyOnes !!!!)
Are these shrouds still available ? OK ,I see them listed ,that`s a good thing.
I too would like to know what`s involved in removing the front site ,as I have an `06 CZ858.
Cheers
Paul T
Last edited by BlackBrant; 11-03-2014 at 07:47 AM. Reason: added
NFA member
CSSA member
Delta Waterfowl member
Ducks Unlimited member
I NEVER MET A LIBERAL ,I EVER LIKED. Will Rogers
will this fit on my brs99 non rest barell..
Although both barrels have an outside diameter of 14.96 +/- , the amount of exosed barrel is different in both guns ,with the CZ having almost 3 1/2" less than the brs99 (I have both ,with my brs having the shroud already installed)
Also ,from what I gather ,the shroud for the CZ may be threaded on the muzzle end to screw onto the male end of the barrel ,and set screws to keep it from unscrewing ,although I may be wrong.
Paul T
NFA member
CSSA member
Delta Waterfowl member
Ducks Unlimited member
I NEVER MET A LIBERAL ,I EVER LIKED. Will Rogers