10 Rnd LAR-15 Mags In-Stock

[KeltecFan]

Then sell all your guns because rumours have been floating for years that Canada is going to ban ALL civilian ownership of firearms... wait, lets ask if anyone can confirm it

Mark

It's on the Internet! It must be true. Oh, wait. So is the "Add to Cart" button.

[Silveragent]

SLIDE THE EXISTING FLOOR PLATE OFF BEING MINDFUL OF THE SPRING. Then slide the coupler on in its place. Repeat for second magazine. To take the old one off, you need to apply upward pressure to get past the little divot. I use an "all" in the little hole, some folks use a little micro screw driver under the lip. Easy peezey lemon squeezey.

Thank you for your instructions Tuco. I stared at mine for a good ten minutes before I found your instructions.

[SVTong]

Are these compatible with standard AR magazine floorplates (Magpul Ranger plates et al)?

[Unregistered_]

Are these compatible with standard AR magazine floorplates (Magpul Ranger plates et al)?

Would like to know this too...

[Musky Hunter]

Yes.

[corney]

I am finding these mags are a bit harsh on the edges of the mags. Not feeding great and scratch the hey out of the brass. Read that the front of the mags need to be filed and the other sharp edges could use a bit of emery cloth. Am I the only one finding these issue?

Don't want to over file and cause grief but they don'"t slide forward easily, hang up on the brass on the way out!

Bit off assistance would be appreciated. Posted elsewhere on the forum but I lost track of it and got busy.

[jasonn]

Can these new mags go in on a closed bolt or are they the same as the others in that respect?
Thank you
J

[Questar]

I am finding these mags are a bit harsh on the edges of the mags. Not feeding great and scratch the hey out of the brass. Read that the front of the mags need to be filed and the other sharp edges could use a bit of emery cloth. Am I the only one finding these issue?

Don't want to over file and cause grief but they don'"t slide forward easily, hang up on the brass on the way out!

Bit off assistance would be appreciated. Posted elsewhere on the forum but I lost track of it and got busy.

If you have any issues with mags purchased from Questar then please contact our office by email: Sales@Questar.ca

Make Scott aware of the problem and he will assist you and get it resolved.

[KNO3-]

LAR mags and couplers purchased...every time i come on here i spend money now!

[corney]

If you have any issues with mags purchased from Questar then please contact our office by email: Sales@Questar.ca

Make Scott aware of the problem and he will assist you and get it resolved.

Well thanks for that and I will when I get a chance to really try them out. Service has been great to date!