ADM Aimpoint H1 Mount and 3x Flip Mount - 1/3 Lower Co Witness

[A.T.R.]

OST,

I am looking in the near future for the ADM Aimpoint H1 Mount as well as the 3x Magnifier flip mount, both in the 1/3 lower co witness models, QD release.

Any input on when these may become available?

C.

[One Shot Tactical Inc.]

I will look into it tomorrow and see what I can find out for you.

[Rock Out w/ Ur Glock Out]

Ive been in need of an Aimpoint H1 mount that will co-witness magpul BUIS, can you offer any suggestions on product that you currenly carry or can obtain?? QD would be preferable. Its all going on a DDV5 and may be coupled with the 3X magnifier down the road. Thanks in advance

[A.T.R.]

I will look into it tomorrow and see what I can find out for you.

Roger that.

Thanks.

[One Shot Tactical Inc.]

Ive been in need of an Aimpoint H1 mount that will co-witness magpul BUIS, can you offer any suggestions on product that you currenly carry or can obtain?? QD would be preferable. Its all going on a DDV5 and may be coupled with the 3X magnifier down the road. Thanks in advance

I will include this in my research tomorrow

[Rock Out w/ Ur Glock Out]

Your the man!! This will be my first time purchasing from you if you can get it but im sure it will not be the last as I have heard many good reviews. Im sitting here toying with the DDV5 as we speak. Love it but hate that I cant use the sight. I have no riser so its almost impossible to use!!

[One Shot Tactical Inc.]

Ok, it took longer than planned to reply but here is what you can do with the Knights Aimpoint mount

The mount can be found here on the website KAC Quick Release Aimpoint mount

The mount comes complete with the quick detach base, riser and 2 shims

If no risers are used you can see that the BUIS are in the top third of the Aimpoint, not good for co witnessing but should you only use the Aimpoint as a stand alone then this will give you the the lowest height over barrel



Install one riser and you are in the center of the Aimpoint



Add the second riser and you are 1/3 cowitness


Should you not be wanting co witness there is another option form KAC, this is the NVG mount located here on the web site Aimpoint NVG Mount

This mount will give you a high mount also with the quick release base as shown in the below picture


Hope this helps you all and shows you the versatility that is designed in to KAC products

[Max Owner]

Hows that for service.

[Rock Out w/ Ur Glock Out]

Top notch!! Thank you for your time good sir! Above and beyond is an understatment

[Rock Out w/ Ur Glock Out]

I do very much like the versatility of the KAC! Id like if it were slightly less in the dollars department but you do get what you pay for!