Run the lower displacement hard or the larger in spec and you get the same. No replacement for displacement.
However, the 7mm RM mag loads identified on the hodgdon site are ....in a word..... anemic.....rather whimpy imo. Recently developed a 162gr load with H4831sc using 65.5gr and wow does it print small groups. At a full 1.5gr over listed it remains within my acceptable upper pressure limit. It is close to practical max as 66.0 gr started to show primer evidence and harder bolt lift....stopped there as felt no need to test crappy brass life. No chrony on it yet but I am betting I am in the 2950 to 3000fps range with a 24" barrel. 280 will have a hard sell to catch that with a 22" barrel.
I'll stick with the 7RM.
Elky....
I would agree with anemic. I've gone well over lots of 7RM data but always watching the chrono.....




















































