Wolverine's WK180-C

Status
Not open for further replies.
Very cool!!!!


Please take into consideration about the possibility of maybe taking AK mags etc... for the 7.62x39 version might be a bit lore receptive then the terrible x39 mag offerings (yes I know minus the 10 rnd pistol mags)
 
So, to sum up - if I got this right from reading the first post - rifle is based on an AR180B machined upper and lower and has a railed front end, heavier AR15 barrel, ambidextrous reciprocating charging handle, modified gas system and bolt carrier, AR15 Buttstock assembly, but does not have a bolt hold open and deletes the AR180B ejection port cover. Outstanding work!

I do however, have questions for Wolverine,
1. What kind of testing has been conducted to date ? I've seen the two videos posted, but curious as to the extent of the testing to ensure that all the kinks have been worked out given the modified gas system and bolt carrier.
2. What are the expected replacement/ wear rates for the components: bolt, spring, piston, barrel ?
3. Can you post a picture of the bolt especially the rear ? Curious to see how carrier tilt is being handled.
4. Can you post pictures of the rifle itself ? Even if it is pre-production.
5. Is the barrel chrome lined ?
 
Last edited:
Will uppers be available down the road, and will said uppers fit the AR-180B?

Ooops should of read the whole post before asking...
 
nicely done Wolverine!

if I didn't already have my 5.56 guns I'd be all over this

now a .50 beo...

or maybe .458 socom, mags properly marked and with caliber specific follower would get around the beo mag predicament?
 
bfiles said:
Very cool!!!!


Please take into consideration about the possibility of maybe taking AK mags etc... for the 7.62x39 version might be a bit lore receptive then the terrible x39 mag offerings (yes I know minus the 10 rnd pistol mags)
Click to expand...

We are considering using AK mags because of over seas markets. Nothing definite yet.
 
Quick question about the barrel.

You say it takes standard AR15 type barrels so does that mean I would be able to purchase an off the shelf AR15 barrel and install it on this gun without having to make any modifications?

Is there any difference on the barrel in the location or size of where the gas block installs? If it's standard what diameter would it be (.750?), also which gas length (mid or rifle length?).

Thanks
 
also.. is that an adapter block used to mount the AR stock?

could we see different adapter down the line? say for a zhukov...? :D

KODWK180CONLINE.jpg
 
Status
Not open for further replies.
Back
Top Bottom