3D printing reloading press accessories **Bullet Feeder Project**

Yes, this is basically a scaled down version of the Mr. Bulletfeeder where thee bullets exit on the top, there is a second one that is a copy of the Hornady where the bullets drop from the middle.

either works well, but this one has more options to do with it.
 
Last edited:
NeoPLA, but regular PLA is fine if you set the infill at 30% or more for the supports.

regular PLA for the main bullet feeder with 20% infill
 
also curious where you got your motor & other parts?

I am putting together a list of things that will be required.
trying to get most of it on amazon.ca
looks like I can get the motor, LED's, photorelay, speed controller from the .ca site
the springs will have to get from DAA
will also need to get a new feed die for my hornady Lnl and the PTX setup.
 
Very nice!!
Figuring out if it would work for me cost wise or that I will make one out of other material. Are you willing to share how much the ballpark price is for the filament needed to print the housing and the 4 different caliber disks?
 
Will post a complete parts list later today , ballpark cost is about $50, more if you use the photo sensor. I ordered extra parts for everything and have the switches and sensors to test. For the slings you can get tube bender springs from any hardware store for $8

It is the bulletfeeder on Thingiverse
 
I found everything on amazon, springs from Princess Auto

Akito said:
also curious where you got your motor & other parts?

I am putting together a list of things that will be required.
trying to get most of it on amazon.ca
looks like I can get the motor, LED's, photorelay, speed controller from the .ca site
the springs will have to get from DAA
will also need to get a new feed die for my hornady Lnl and the PTX setup.
Click to expand...
 
bertn said:
Very nice!!
Figuring out if it would work for me cost wise or that I will make one out of other material. Are you willing to share how much the ballpark price is for the filament needed to print the housing and the 4 different caliber disks?
Click to expand...

Filament cost was $17.50, I printed 2 sets with caliber disks and used less than 1 spool
 
awesome, looking forward to the list. i have been reading the posts on the castboolits forum and it's been interesting.
main thing I need to find is the motor with the pin through the shaft. ones I found on amazon don't seem to have that.
 
You must log in or register to reply here.
Back
Top Bottom