Somewhere in this pic is my 10.22.. Can you find it?

Plink

Plink

CGN Ultra frequent flyer
Rating - 100%
54   0   0
Location
Having a boating accident.
Bit of cabin fever setting in, so I got to finishing up my 10.22... Got a Tac Sol barrel a while back, and fixed up my Tapco stock to fit it. Today I got at it with a rattle can..... :evil:


Whadya think?? Does it show up in the pics??? LOL :50cal:


camo1.JPG


camo2.JPG


camo3.JPG



It's my first attempt at a camo job, I think it turned out ok considering!
 
It's a modified Tapco T6 stock. I got it shipped up from the US. Gunacessories.com I think is where I ordered it from.

There's another post on this page from a fella named alechs who has done the same thing to his stock.
 
I was looking at those stocks but it says it can only be used with a regular barel and not a bull barel.Did you modify it yourself?
 
Yes, there is actually a top for the for stock which won't work with a bull barrell. So it's not on there anymore. I did the clearancing of the fore stock with some sand paper wrapped around a handle for a hydraulic jack. It's just the right size!! You know, the red bottle jacks with the two piece handles, use the big end. Works perfectly and didn't take to long at all.
 
Plink said:
Yes, there is actually a top for the for stock which won't work with a bull barrell. So it's not on there anymore. I did the clearancing of the fore stock with some sand paper wrapped around a handle for a hydraulic jack. It's just the right size!! You know, the red bottle jacks with the two piece handles, use the big end. Works perfectly and didn't take to long at all.
Click to expand...

Hi Plink, nice rifle.

I opened up the barrel channel on my Tapco for the Tac Sol barrel by wrapping a 13/16 deep socket with 600 grit wet and dry sandpaper. Took about 20 minutes.

With the action mods it went through 500 rds of subsonic this past week with no problems, very accurate.
 
You must log in or register to reply here.
Back
Top Bottom