NEA Tavor Rail System

The current design fits the requirements for users with a short barrel (military). It also allows them to use the current irons. We have been finalizing this design with the customer for three months.

You should consider making it longer for more real estate.
 
Ok ladies,

The design has been finalized with our two over sea's clients via Troy Ind. qty's are so good we are going to run a special on 100 sets exclusive to Canada. This is our thank you to CGN and its membership.

We are going to offer the whole system for $180.

We are expecting a Sept launch date.
 
so after a few changes, we believe we have the final version scheduled to go on the machines within two weeks.

We are also making a quick release rail to work off the mounting area behind the rear factory.

The rail system will allow a full co withness using factory irons and a micro.
 
so after a few changes, we believe we have the final version scheduled to go on the machines within two weeks.

We are also making a quick release rail to work off the mounting area behind the rear factory.

The rail system will allow a full co withness using factory irons and a micro.

Ok, without a picture at this point you are just teasing us :(
 
Looks great! It's nice to have a longer rail that still allows factory iron useage. It looks like there's no permanent alteration to the rifle required to mount this, correct? i.e. the owner can go back to the original configuration at any time?
 
Ok ladies, i will have pictures for you the end of next week and we expect to start shipping the following week.

This will be a limited run for the Canadian market, when they are gone they may be gone for a while as we are running this batch to provide samples for military contracts that we have been invited to bid on.
 
Looks great! It's nice to have a longer rail that still allows factory iron useage. It looks like there's no permanent alteration to the rifle required to mount this, correct? i.e. the owner can go back to the original configuration at any time?

no, nothing permanent, no hacking or sawing off integral components.

We also have a QD sling point for the butt stock and tritium sight set in the works and should be out in oct.
 
I can do better. We will be shipping by the end of next week. When they come back from Anodize i will post pics. The last time i posted pics of a spray canned rail guys were upset at the color difference. i think you guys can wait one more week?????? ahahha.

We are running 75 sets, half of which are leaving Canada for evaluation as a requirement for several RFQ's we are bidding.
 
Back
Top Bottom