What's the extractor on the Dlask 10/22 bolt like?

[blsonne]

My Dlask 10/22 bolt just arrived, a very nice piece of work (nice radius, hope that lets me cycle the subsonic rounds)... too bad I installed it before I remembered that I wanted to take the extractor out and compare it to the an old factory one, as well as a spare Volquartsen I have hanging around.

So, Dlask, do you have any pictures of your 10/22 extractor you could share? Is it EDMd?

[Hodaka]

I believe the description on the website said it is wire EDM.

[blsonne]

excellent

[Hodaka]

Yup. Yanks 'em out good so far. I rapid-fired through my 110rd GSG mag yesterday, and it flung the brass nicely!

[blsonne]

Oddly enough, that is the exact magazine I will be doing the same thing with You have good taste, sir/madam.

[Hodaka]

Btw, subsonics may still need a little help - which are you planning on using? I was trying to run the 710fps stuff in my 16.5" DAR - close! I have the Dlask guide rod and 10% reduced spring, and it seems to need some break-in still - thus the 110 round dump.

[Hodaka]

PS: they call me Mister.

[blsonne]

I'd be shooting the CCI Quiet-22s, which are 710fps I think.