Oh me likes, this is nice.
Will mags from a CZ 858 fit these new guns?
Looks pretty sweet, and it's fantastic that you guys are doing this, but I don't know if I'll buy one personally.
Requiring tools for disassembly is a huge drawback for me.
Also, is there any way we might be able to get the back of the reciever/rail machined on a bit more of a slant? As others have stated, it would look way more aesthetically pleasing.
I'd be more than willing to pay a bit more for said machining and some kind of two pin disassembly system.
Yes, the only negative point i see with this firearm are the screws to take off the cover.
How many screw/unscrew cycle can they take before begining to strip ? When they do strip, will they strip the receivers threading too? When the receiver threading is stripped what can be done ? How much ?
If that is the cost of holding zero, i'm not sure its worth it.
Pins would have been so much better.