 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
yes they will have the grooves on them, that is the last op on the lathe and depending on how deep the threads are on that model of tube as to how deep we cut the threads.Originally Posted by Sumonda
Looks good, will the final have grooves on the thread nut or remain smooth?.. Also have you worked one up for the Hatsan pump?
And yes the tube for the MPA optma pump is also prototyped.
we will be testing these out at the range today
Not bad, but what about making it long enough to be flush with the end of the flash hider like this (see link)
http://sjhardware.com/store/modules....roducts_id=735
Mine is a no gap thread
Ok the pump of semi mpa?
Ok I see, maybe the flash hider diameter is too big to allow the tube to extend further. great work!
yes it is, someone one here is working on a new comp for that hatsan, I talked with them but been so busy I forget who it was
bbb
The credit card is cleared, ready, and waiting for this Hatsan "thread gap version" extension.
here is the prototype of the hatsan mpa long thread mag tube.
these are being tested at the range tomorrow
"You may not like guns. That is your right. You may not believe in God. That is your choice. But if someone breaks into your home, the first two things you are going to do are… Call someone with a gun and Pray they get there in time." - Unknown
this post you quoted is it, we have been making them today.
they are up for pre order with free shipping, eta is 31 oct.
use promo code HATSAN
ORDER HERE
http://sjhardware.com/store/modules....roducts_id=974
The credit card is cleared, ready, and waiting for this Hatsan "thread gap version" extension.
Already ordered from your other thread that has the link but no promo code. Will the shipping charges be changed before the credit card is charged?
when did you order? in the last few days?
if so I don't see an order
what is the order number
Posting Permissions
Reply With Quote
