Hi there, BC Interior M14 lovers....
I can finally say it's official and I'm gonna be there in Kelowna!I realize it's the middle of the week but that's how my calendar is shaking out.
Where:
Joe Rich Gun Club (address to follow)
Location of range and clubhouse is: 13620 Hwy #33. Which is south of Kelowna and just before the hill up to Big White Ski Resort road intersection at Hwy # 33
When:
Tuesday 22 September 2015. One day of clinic tweaking.
Cost:
$ 50 for the DAY
Timing:
Gather for 0830
Casual Start at 0900
Lunch at 12ish to 1ish... might have to bring lunch
Ending at 1600
Registration and Payment:
EMT the $50 to me with this information:
Name: Tactical Teacher
Question: What was your OLD CGN handle? I was not always tacticalteacher, you know.
Answer: hungry (low caps, no spaces) that way I cannot screw things up
Email: hungry556 AT bell.net
Somewhere in the EMT, remind me of your CGN handle AND which clinic it's for (PR or CQB or M14)
What is involved:
- Tools for tweaking, tools to avoid, tools that are nice to have but expensive, tools that are overrated and too expensive
- Gadgets that are nice to have, need to have, and useless to have (but I had to buy it to show you)
- Tools that you can make yourself instead of buying, tools that you can have buddies (owe you favors) make up for you
- Stripping the boomstick (you will be surprised at what I can show you)
- YES we will try to pull your rear sights apart, and then get serious with them
- Assembling the boomstick, and what to look for so that worthwhile tweaks can be or should be made
- Tweaks that work, tweaks that don't work, expensive tweaks so yer dick does not fall off
- Useless tweaks unless you have more money than shooting ability (many stories to follow at the clinic)
- Common pitfalls, expensive tweaks that work, more ways to ensure that yer dick don't fall off
- Lunch and then tweaking in the afternoon to tighten up your prized M14
- Lots of networking and socializing all the time. This is priceless.
- I am set up to install your .308 Win barrel on your receiver and then FINISH Chamber, then you test fire at TSE
Things to bring for Day 1:
* Your M14 rifle or receiver(s) with barrel(s) to be installed
* Your M14 (or two if you got them)
* Notebook, pens, digital camera, rags,
* Ball peen hammer, Allen keys SAE and Metric
* Punches, screwdrivers, more punches
* Plastic or rubber mallet, wood block or 2 or 3
* Masking tape, duct tape
* Anybody got a Black and Decker Workmate? Bring it along, leave it inside the car/truck until we need it.
Questions?
Bring them on!
Cheers and warm regards,
Barney
|
Originally Posted by GUB
