G9 Mag Adaptor, Pics and Installation thread

[magpul79]

Are there none left for sale? I can't locate them on your website.

[MagWedge Industries]

Are there none left for sale? I can't locate them on your website.

The pre order is closed now but I will post some for sale in about a week.

[Canuck44]

Mine is on the way. Once it arrives it goes straight to my gunsmith. I know my limitations. I have a tapco stock on my SKS which will need to be modified which should not be a problem for him. I'll post the finished project in a couple of weeks. Looks like a winner to me. I would have preferred a conversion kit for a CZ 858 to make the cost a bit closer to the price of a rifle but it is what it is, Either the SKS is under priced ot the CZ is over priced.

Take Care

Bob

[sametwinnie]

Do you think it's possible to do the modification with a drill press and a small milling table?

[MagWedge Industries]

Do you think it's possible to do the modification with a drill press and a small milling table?

Yes. Obviously better tools will be faster and cleaner but a drill press with a milling table isn't bad.
I do believe you need to consider carefully what bit to use in the drill press so l will see if I can get some decent advice on that for you.

[G37]

Nice looking product! I'd definitely consider a completed SKS (w/plastic stock)
Nice work!!

[sametwinnie]

Yes. Obviously better tools will be faster and cleaner but a drill press with a milling table isn't bad.
I do believe you need to consider carefully what bit to use in the drill press so l will see if I can get some decent advice on that for you.

I will probably use a 1/4'' end mill

[MagWedge Industries]

I will probably use a 1/4'' end mill

Yes, that sounds about right.

[Canuck44]

Got my postal notice the other day. Have you dropped them in the mail Dave?

Bob

[MagWedge Industries]

Got my postal notice the other day. Have you dropped them in the mail Dave?

Bob

Have them here with me at work and dropping in the box at lunch.