Just got my NR APC-223, must say its a beaut.
Got a couple questions for the fine folks at wolverine.
1 - how do you remove the hydraulic buffer from the factory stock? Looking to retrofit a ACR stock on there and dont quite understand the design of the hyd buffer, and dont want to wreck anything.
2 - Are replacement fore-ends available? I plan to drop mine off with the machinist soon to be further lightened and have Mlok slots milled... in the unlikely event that something goes wrong, can I purchase a replacement?
3 - What is the factory finsh on the fore-end? I assume its annodizing, just trying to figure out what my chances are of finding a cerakote shade that matches close enough.
4 - If i wish to go to a restricted length in the future, can I purchase the restricted conversion from you folks, or will I have to sell and rebuy/get a custom barrel made?