Yah I was watching that. It still doesn't mention anything about that lock for rotating the barrel locking cam.
And what's the point of the tiny little wire with the bolt retaining it on the new bow
Yah I was watching that. It still doesn't mention anything about that lock for rotating the barrel locking cam.
And what's the point of the tiny little wire with the bolt retaining it on the new bow
If you take a punch or small allen wrench an press on the dimple on the locking cam you will see it cantilever out. Once it is out, it's unlocked but needs to be held open to rotate your barrel wrench. I made my own wrench out of a larger allen key. I believe this is gone over in your Tavor manual. I was worried with how much force it takes to rotate but after the first couple times I knew to expect it.
I agree, the gentlemen at Arms East are top notch to deal with. From reviews I've seen if you were to only get one (the bow or trigger pack) many people recommend the Bow first.
Watch the military arms channel video on the disassembly of the tavor for instructions to remove the barrel.
The little wire sets the pretravel and the reset of the bow. After you install the Bow you need to adjust the the screw until you are happy with the trigger and it resets reliably. I had to take it apart and put it together 3 times until it was good.
3 times! I think I had my barrel off and on 10 times before it was set up. Had the change down to a 10 minute job by the end.
Moe
I have the Super Sabra Trigger Pack. just trying to figure out when I should get the Lightning bow lol
There should be no figuring. Get it. Both transformed my tavor from the last gun taken to the range to the first gun. Its undeniably the two most incredible upgrades ive installed on any firearm i own.
Last edited by ARMS EAST; 06-20-2016 at 05:19 PM.
www.armseast.ca Toll Free 1-844-579-0007 EMAIL info@armseast.com