Any idea when the jig for the CZ scorpion is going to be ready?
Any idea when the jig for the CZ scorpion is going to be ready?
They don't read this forum
A jig won't really help. You have to do an undercut with a woodruff cutter and that requires a milling machine. Milling machines eat jigs in a way that a dremel won't.
Uh Ya! They have stated in another thread that they are working on a jig for finishing their aluminum lowers. And yes they did address the cutter issue stating that these jigs will be more complex than a AR jig and would need a milling machine (mandatory) for use because of the need for the woodruff cutter, nobody even mentioned the word "dremel".
If you need to use a woodruff cutter or a key seat cutter just put it in a regular drill press and use a cross slide vise to make the cut, thats how people were doing their rails on 1911 80%
That won't work as you can't get access to the underside in the spot that you need to I don't think. Works on rails but not an enclosed are like this. I'm not a machinist thought.
I don't think those cuts are necessary to function though as the 3D printed receivers omit them.