I was looking at the Mosin sniper rifles on your site and was wondering if the scope mounts require shimming or grinding to zero the rifle? I saw that some people had that issue with the repro mounts and scopes
I was looking at the Mosin sniper rifles on your site and was wondering if the scope mounts require shimming or grinding to zero the rifle? I saw that some people had that issue with the repro mounts and scopes
To be fair it's not too hard to do. If it's too long, then VERY SLOWLY remove a bit of material, check, remove, check, remove, check. If you need to add shims, then get yourself a ten dollar set of feeler gauges. You get a wide variety of widths that you can use to get real close to true.
it is installed so it is zero in. You may need some modification depending on your needs
Al