-
80% Jig Markings
The markings on the top plate #3 say 5/16 endmill - 3/8 shank.
The slot isn't wide enough for a 3/8th shank thou...
Anyone else seen this?
-
-
CGN frequent flyer
I bought an early jig set and there was an issue with the slotted jig plates being reversed and I believe there was some mislabeling as well. I can't find the email I sent to Dlask with the specific details but Leigh took care of it and sent new plates. I will check mine as I still have the old incorrect plates but it sounds like you might have the same issue.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules