What AR500 targets do you want?

[Gatehouse]

thanks for changing my post,it makes me wonder if the miracle of sponsors changing the content of posts is appropriate. what a lovely operation you have here

Well, you were advertising on their forum that is paid for by them. Which is against CGN rules and impolite. What did you expect?

[surplusshooter]

What's wrong with T-Rex?

I second this and want to add raptors

[michaelsabre]

Would 2'x2' be too big?

My calculation shows that will be 80 lb. You better have a truck.

[dand883]

coyote , ram , turkey . and all of the one hickok45 has :P

In addition to the ideas above how about some smaller knock down targets with a base attached to stand on the ground or a 2x4. Maybe 4-6" round, square or mini IPSC shaped. Could sell them in sets of 4 or 6.

I would be more likely to buy several small plates that i can stand up, turkeys and gophers and such would be cooler, but small rectangles or circles i assume would be less expensive to cut out

[CraigNConnor]

thanks for changing my post,it makes me wonder if the miracle of sponsors changing the content of posts is appropriate. what a lovely operation you have here

[CraigNConnor]

Double post

[Aniest]

Love to see a 10" wide, 8" tall plate to simulate a vital organs location on an animal. Great to place a cardboard cut out in front of the plate, or paint the plate to match the cardboard target cut out, to practice on: hear the steel ring it's a vitals shot... no ring, it's a lost animal.

Water cut and 1/2" please.

[Aniest]

I do weld, and I can tell you you don't want to weld to these anyways. You put a solid weld on the back of one of these plates you'll take the temper out of the steel. And that's where it'll crack and spall. That's why targets are also worth buying unless you have access to a water jet. Torch cutting wrecks the hardness. Even plasma will put too much heat into the edge of the target and make it brittle.

Yup: I actually put standard lead core FMJ S&B .308 through a 3/8" AR550 plate 1" from the edge at 150 yards because it was heat cut. I'd want cold cut or not at all.

[CplDogNuts]

16" and bigger gongs/plates , and full size torso silhouettes.

[AB.boy]

Any news on this? What types of targets have you decided to produce first? Do you have an ETA?