The rifle length is softer shooting and almost all top notch 3 gun guys prefers rifle length gas.
your dimpled barrel 18.6 + rifle length gas would be a very nice setup.
The rifle length is softer shooting and almost all top notch 3 gun guys prefers rifle length gas.
your dimpled barrel 18.6 + rifle length gas would be a very nice setup.
Last edited by Familygunnutz; 11-18-2017 at 03:02 PM.
Get some!!! ^^
Thanks for the feed back, this is something we can look at on the next run, if we do them, we have been running a Mid lenght on a 14.5 16.1 and am 18.2 for about 5yrs now, i do like the balance, but we just them mostly as carbines, not full size rifles, but again somthign we can look at for sure on the next run.
At this point i think we will be sold out of this run by next week .
If you decide to add rifle length gas to the next run I will be buying for sure.
Get some!!! ^^
Could these be made available without the gas block and gas tube. Id like to put an Adams Arms piston system on my gun but use this barrel. LMK if that an option or if it would even work they way im thinking. Ill place an order right away if it is possible.
How long is this preorder on for?
Few posts up he's thinking they'll be out of spots for the run this week.
I asked this in the other thread but I'll ask here as it seems to be getting more action:
Is it possible you will do a pinned gas block on future runs or is it possible to pay a little more to have it done by you on this run?
this is something ill , ask my gun smith do, as it will requite us to make an jig and index each gas block and and of course drill the gas block and barrel at the same time. and pin it
this is normally something i would only do when building a gun.
The other issue may be getting a taper pin small enough as out gas blocks are very low profile.
would you be happy with a straight pin not a taper pin?