So ATRS I'm confused, you say these are in production but your waiting on the FRT. In previous releases of yours, once you got the approval, how long did it take to get the FRT. Im hoping i got the correct sequences there.
So ATRS I'm confused, you say these are in production but your waiting on the FRT. In previous releases of yours, once you got the approval, how long did it take to get the FRT. Im hoping i got the correct sequences there.
Why does it look like there is a screw by the selector lever? Kinda where a rear take down pin would go. Tell me it’s not a screw.
ATRS, I saw it was discussed earlier in the first thread pages.. but can you verify the material used? 6061 or 7075 aluminium for this new set price?
Keep ignoring requests for silly features à la forward assist et al. and mass produce these ASAP.
A tiger in Africa?!
That's definitely a screw for takedown. I'm going with the WK-180.
What are you looking at?
The larger picture in post 176 shows a push pin above the safety selector - with a recess in the end for a pushing device or bullet tip.
Thats initially what I thought but if that's the case this push pin is pushed from the opposite side of a ar15. Then I thought it might be a allen key screw. ATRS can you confirm?
Just got email from ATRS. the take down method is similar to MV with 1 take down pin.
Not sure what that ugly screw is...