So after almost a year of being out of stock we have finally had time to finish a run of our CNC hand guards for the DA Grizzly shotguns. Found here on the website :
https://dlaskarms.com/products/domin...uminum-forearm
So after almost a year of being out of stock we have finally had time to finish a run of our CNC hand guards for the DA Grizzly shotguns. Found here on the website :
https://dlaskarms.com/products/domin...uminum-forearm
Cheers,
Leigh
Dlask Arms Corp.
www.dlaskarms.com
“Hard times create strong men. Strong men create good times. Good times create weak men. And, weak men create hard times.”
These won't work with the mag fed 8.5" grizzly?
Last edited by cyphie; 11-27-2017 at 08:07 PM.
Do you need a new tube? Pics on a standard gun?
Im slow...but would it fit a reg Rem 870? Express or Police or Marine?
No Sir, you don't need a new action bar. Simply remove the castle nut on the forward end, remove the plastic POS that comes with the gun and then install our CNC unit and replace the castle nut. Takes about 1.5 minutes total to change and makes a 100% difference in the look and feel of the firearm.
Cheers,
Leigh
Dlask Arms Corp.
www.dlaskarms.com
“Hard times create strong men. Strong men create good times. Good times create weak men. And, weak men create hard times.”
Cheers,
Leigh
Dlask Arms Corp.
www.dlaskarms.com
“Hard times create strong men. Strong men create good times. Good times create weak men. And, weak men create hard times.”
Is it just me or is this version a little bit different then the older ones you made. These seem a little less “bulky/squared”. These look a lot better