Just looking for the torque specs for a set of MDT 30mm rings.
Thanks
Just looking for the torque specs for a set of MDT 30mm rings.
Thanks
Educated guess, 18 INCH pounds on the rings.
Defund the Liberal propaganda ministry, AKA the CBC.
Democracy is not a spectator sport.
I'd check with the scope manufacturer. You are tightening against the scope tube body so they are more likely the better source for torque specs, rather than the ring manufacturer.
Newfie torque. Tighten untill it strips then back it off 1/8 turn
18-20 on rings and 25 on the base.
...
Last edited by 6MT; 02-21-2018 at 12:30 PM.
Yes, I would either call or email them, just in case.
I have a bunch of different rings and bases, they all are in the range I said, but you never know.