Tonight I tried to take apart my wk 180 c and clean it for the first time, after taking out the charging handle and the guide rods and springs the bolt carrier slid forward and will now no longer retract or come out to the point where I can reinsert the charging handle. It seems to be getting caught on the upper receiver.
Please advise what I should do? Basically, it is stuck in the upper receiver and can move back and forward but not enough to put the charging handle back in or remove the whole BCG
Last edited by JammyD; 06-04-2019 at 09:16 AM.
Quick question....can you use grease on the bolt assembly...specifically where it rides in the grooved channel?? Or would oil be enough.
CCFR Member
For those of you have have removed/replaced the stock adapter block, is the locating dowel on the receiver or the adapter block?
In the early production pictures, it appears to be on the receiver. On my rifle, the dowel is on the stock adapter block.
Looking at pictures of the RWA ACR stock adapter, it has two holes and no dowel.
Anyone knows the ejector roll pin, B8?
I only see a hole...no pin there. Did they remove it on the new productions? Actually my rifle could function without the pin...
Thanks!!
Last edited by tulazhen; 06-15-2019 at 11:18 PM.
Political correctness, cancel culture and allyship are communist tools.
Laws and orders keep a prosperous society.
Disarming citizens for safety is a blatant liberal lie.
--------------------------------------------------
"If sense is so common ..... why is it in such short supply?"
Frazen lock works in mine