removed comment.
removed comment.
Last edited by Cee-8; 11-09-2018 at 12:05 AM. Reason: Not appropriate for this thread
What's the gas block profile? 0.750" ?
S#it can go south people. The space shuttle blew up twice. - Clint Smith
Communists aren't people.
No machining necessary - there is a chamfer around the bottom slot that allows for the use of a standard O-ring.
See
https://www.canadiangunnutz.com/foru...cheap-solution
L
--------------------------------------------------
"If sense is so common ..... why is it in such short supply?"
That seems to add upwards pressure on the upper which was what i was trying to avoid. I think having orings on near the top and bottom of the lug would be better because it uses lateral pressure to tighten up the lug. Any upwards pressure causes torque on the disassembly button, upper receiver, and recoil guide base would wear it out eventually.
What is the distance from the muzzle to the lower tip of the handguard? I'm guessing 5.7" since the barrel is 18.7" and the handguard is 13"? Thinking to fit a barrel shroud on it.
Can a printable FRT be made available ?