CZ Bren 2 MS Drop-In Barrel Parts Question...

[Dlask Arms]

Hey guys. We have had a TON of folks asking about a spare trunnion and gas block set up for their Bren 2 MS rifles that we have converted. I have a line on the parts but need to gauge if there is really is that much interest or if it's just a couple people ..

Before you ask, cost for these parts will run about $600-$700. This is :

-Trunnion
-Gas block
-Gas Regulator ket, spring and roll pin
-Gas regulator for the spare barrel your rifle came with

This makes the rifle barrel changeable by removing a few Torx screws, remove / replace barrel, re-torque the Torx and off you go.

If you want to change CALIBER that could also be something we look at. These are the things we think about at night....



Let me know on this thread and if there is enough interest we could make this happen.

[mrsmitty]

I would be down with this. Need to save some funds for it since the rifle itself broke me but in a few months I definitely want this

[Canman]

I would be interested.

[Tvw]

Interested.

[Danol]

300 blackout 18” barrel possible?

[Dlask Arms]

300 blackout 18” barrel possible?

Don't see why not, there is an N/R FRT entry for it.

[Nismojunky]

I’m down for 2 sets

[CobraGT]

I'm interested in a set.

[bfiles]

Ohhhhh

[x3ck5]

I'd be in for one. Sorry in advance if its a dumb question, is this something i can easily put together myself or would we have to send the old 11inch barrel in?